![]() ![]() ![]() Step-3 Clean with the Abrasive Rubber cleaning stick (grip tape eraser) Remember the board is not waterproof so use only a small amount of water and clean it off with a microfibre cloth afterward. Scrub the grip tape and repeat the step above. If brushing the board is ineffective and you cant remove all the dirt, you could try and dip the brush in some water. Step-2 Apply Water For Heavily Caked On Dirt And Mud ![]() If you can’t remove caked-on dirt go to step 2 else go to step 3. This is an important step as grip tape erasers only work best in removing small particles of sand and dust from the tape Try to force the bristles into the grip tape to remove the bulk of any caked-on dirt, mud, or soil sticking inside the grip tape granulates. Use the brush to brush away any loose or easy to removed surface dirt. How To Clean Your Onewheel Grip Tape Step-1 Remove lose dirt and as much of the bulk of it The same goes for the skate brands out there that sell the same product. It’s way cheaper compared to the official grip tape eraser. Just don’t buy the grip tape eraser, get a natural rubber abrasive cleaning stick made for sandpapers and sanding discs. It, therefore, recommended to not soak the board and wipe away any water before it makes its way into the internals of your board Onewheel Grip Tape Eraser Remember that your board is only water-resistant and not waterproof unless you have badger the board. It’s good to use a microfibre cloth for the last polishing steps of your board or to soak up any excess water after you have wiped down your board or been riding in wet conditions. The erasers are perfect to remove dirt stuck inside the paper between the sand and remove it from your grip tape. The grip tape on your board is basically sandpaper that’s a bit more weather resistant than normal paper. It’s made of the same materials as the grip tape erase, natural rubber, just at a way better price. Getting a generic abrasive rubber cleaning stick for belt sandpaper and sanding disc instead. It works like how pencil erasers remove mistakes on paper but instead dirt from in between the sand particles on your grip tape.ĭon’t buy the Onewheel Grip Tape Eraser or any skateboard Griptape erase. The abrasive rubber cleaning stick is the next step after brushing away debris and dirt. I’m using a bush with a good handle, a dish brush is a cheap alternative to remove stubborn mud and debris.īrushing away loose dirt is the first thing you do when cleaning your grip tape. BrushĪ brush with some stiff nylon bristles is a great tool to remove excess dirt without damaging the grip tape on your Onewheel. As stated above you only need a couple of items so don’t overlook them when you are performing routine maintenance on your board. What You Need To Cleaning Your Onewheel Grip TapeĬleaning your Onewheel grip tape is easy with the right tools. These items are essentials for any Onewheeler because they don’t cost that much and will always come in handy. Microfiber cleaning cloth (to be used in damping or patting the board dry).Brush (any brush with soft nylon bristles).Abrasive Rubber cleaning stick (any piece of natural rubber that would work on sandpapers).Here is what you need to clean your tape. You should always try to clean the grip tape to try and restore it as the first step and once your grip tape started to weaken, then it’s time to change it. The Onewheel front footpad has a sensor underneath it and removing the tape is a delicate procedure. If your grip tape is dirty it’s way better to clean it compared to changing it out. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |